R12T Fuel Filter / Water Separator For Marine Spin-on 120AT Diesel Fuel Filter

Description

Product description
Attention:Please tighten the filter by yourself when installing it.
The filter units are coated with a durable electrostatically applied powder coating for superior corrosion resistance.Remove emulsified water and particles down to 10 microns in size,ensures that fuel arrives at your engine clean and water-free with its advanced high-capacity filter media.Provide best protection to your engine and improve its performance.
This spin-on filter design is easy to replace and the reusable clear nylon collection bowl and features a self-venting drain for removing unwanted impurity and water.Tighten the valve,the water will not discharge.Release the valve,the water can be free to discharge.
Filters are designed for high performance applications,and with flow rate of 30 GPH on the R12T model,your engine will perform better than ever with clean,water-free fuel.
For R12T Marine Fuel Filter/Water Separator complete assembly.NPT,ZG1/4-19.(Port/Connecting Size M18 X 1.5 Center Thread)(Include 2 fittings,2 plugs).Part Number:Replaces S3240 R12T 120AT;Replaces 18-7987;Replaces RK10222.
If you have difficulty in installing, you can go to YouTube to find the appropriate installation video:https://www.youtube.com/watch?v=LyeqTDVzY-A.
Specification:
1.Fuel Water Separator Filter fit 3/8 Inch NPT Outboard Motors as well.
2.Maximum Flow Rate 30 GPH (57 LPH).
3.Port/Connecting Size M18 X 1.5 Center Thread.
4.These are more suited to compact off road diesel equipment:tractors,skid steers loaders,movers.
5.Filter Rating 10 Micron.10 micron filters are over 90% efficiency at removing particles as small as 10 microns. 10 micron filters are recommended to protect sensitive inboard, sterndrive and outboard fuel injection systems.Designed to trap the smallest particles and emulsified water from Diesel.
Product details:
1.Don¡¯t be caught in the water without one of these diesel spin-on filters.
2.Filters are designed for high performance applications, and with flow rate of 30 GPH on the R12T model, your engine will perform better than ever with clean, water-free fuel.
3.The inlet and out let can be feed in on the same side or in one side out the other side.
4.Check and replace regularly.
R12T water separator and filter complete combo installation instruction:
1.Nylon collection bowl down when installed the water separator and filter.Lube the O-rings of filter.
2.There are 4 ports,two inputs and two outputs. We provide two plugs for the extra two ports. If you need to use two plugs, you must install them to the filter and tighten them.
3.Before installed the filter, you have to remove those plugs, teflon-tape them, and re-install them.Prevent leaks from these plugs.
4.All of the above steps are very easy to operate, you'd better use the tool to install tighten.